Standard wall mounting
Fixed, tilting, and full-motion mounts on wood-stud drywall. We locate and mark studs, verify the bracket is rated for your screen weight, set the height to your seated eye line, and level the finished install.
One trade, done thoroughly. Below is exactly what our technicians handle on a TV mounting visit.
Fixed, tilting, and full-motion mounts on wood-stud drywall. We locate and mark studs, verify the bracket is rated for your screen weight, set the height to your seated eye line, and level the finished install.
Many Palm Beach County homes are CBS construction. We drill with masonry bits and use sleeve or wedge anchors rated for block, and we seal penetrations on exterior-facing walls.
Over-fireplace mounting starts with a heat-clearance and mantel-depth check. Where the height would be uncomfortable, we recommend a pull-down mount so the screen drops to eye level for viewing.
In-wall concealment on interior drywall using low-voltage brackets and a code-friendly power relocation kit, or paintable surface raceway on block, tile, and stone where in-wall routing is not appropriate.
Soundbar brackets aligned to the screen, floating shelves for streaming boxes and consoles, plus cable management behind the console so the room looks finished.
Covered and screened outdoor spaces only. We use outdoor-rated mounts, stainless hardware, and conduit routing suited to Florida humidity, sun, and coastal salt air.
Moving house or redecorating? We dismount safely, patch or cap the old location, and reinstall on the new wall with hardware appropriate to that surface.
Yes. Most Florida homes here mix wood-stud drywall interiors with concrete block and stucco exterior walls. Our technicians carry stud finders, masonry bits, and block-rated anchors, and we choose the anchor system based on the wall we actually find on site.
In-wall cable concealment is available on most interior drywall walls using low-voltage brackets and a code-friendly power relocation kit. On block or stucco walls we typically use a paintable surface raceway instead.
Fixed, tilting, full-motion, and pull-down over-fireplace mounts for screens roughly 24 to 98 inches. If you have not purchased a mount yet, tell the Assistant your TV model and wall type and we will confirm what is appropriate.
Yes, on covered and screened outdoor areas. We recommend weather-rated screens and outdoor-rated mounts, and we route wiring in conduit or raceway suited to Florida humidity and salt air.
Yes. We measure the heat clearance and mantel depth first, and we usually recommend a pull-down or tilting mount so the viewing angle stays comfortable.
Use any Estimate, Book, or Assistant button on this site. It opens our central Assistant right here on the page, collects your details, and routes them to our dispatcher. You can also call 561-506-2278.